Search the Community
Showing results for tags 'tail lights'.
Found 2 results
Hello all, I have been adding the detail parts and dcc'ing a Kato ef58 that i've had for some time. When I took the body off, I noticed that there are guides above the cabs for tail lights, as well as the headlights. Shining a light through the body confirmed that the light was delivered to the lenses for the tail lights, so I set about adding some leds to illuminate the tail lights, as there is space to do so. Inside the ef58. LEDs can be added to the grey box at either end of the model. I used 3mm LEDs, pre wired with a resistor. Grey box removed. The guide for the headlight lens goes through the gap on the left, you need to drill a hole on the right hand side for the light to pass through.
Hi, I installed a Digitrax DN163 in my Kato HO scale DE10. Everything works fine so far but now I want working tail lights, too. There are 3 free function outputs left on the decoder and I want to be able to switch on/off both front tail lights, both rear tail lights and - now comes the difficult part - the front right tail light together with the rear left tail light (for switching). I came up with the following wiring diagram, which shows only the wiring for the front taillights: Will this work? Or is there a better way to do it?