Search the Community
Showing results for tags 'stonysmith'.
Found 1 result
Rokuhan Shorty with stonysmith switcher bodyshell
kevsmiththai posted a topic in Japanese: Other Gauges & ScalesHi all The Rokuhan Shorty chassis has caused a lot of interest recently amongst the Z gauge community, as well as the Nm and H0f guys. but one of the easiest conversions can be done with stonysmiths 'open window' switcher on Shapeways 3d printing site I needed a couple of generic industrial diesel locos to run on Republic Steel which would not look out of place if I was running it in American or British guise. I decided to stick with the ABS printed shell rather than the 3d printed Brass one. They are never going to be pulling more than 2 or 3 ladle cars or torpedo on the layout so haulage weight shouldn't be an issue. The basic chassis straight out of the package The basic shell as delivered and fresh out of the Ultrasonic cleaning bath of warm soapy water The shell is very close to a GE 70 tonner and is a perfect fir on the Shorty. The first thin coat of primer was used to reveal the areas needed the layer lines cleaning up, not much, just some round the nose end and the cab This was one was per the print with the addition of handrails from a Marklin caboose. Exhaust stack was brass tube Now in my efforts to add detail I decided to drill out the headlamp on the other one, pushing a sharp scriber into the centre of it to give the drill bit a centre to work with I managed to punch a hole in it as the material is so thin. Some choice Anglo-Saxon swearing followed and once I calmed down I decided to add a radiator grill from Scalelink etched mesh to hide the hole. Yo be honest I actually preferred the look in this shot you can see the original couplers get in the way and can push the truck down. They are the usual Rokuhan push fit and are easily removed more in a mo Kev