Glue for PLA print plastic

[b.nice2000]

Just thought I'd mention the glue I prefer for gluing PLA prints..

 

Have tried several brands, but this works well for me.

 

https://www.ebay.com.au/itm/225836461458

 

Shane's Shed medium plus 200cps CA glue

 

I have absolutely no affiliation, except that I buy the product  🙂

 

 

[Cat]

I've used Zap-A-Gap in the past, a similar gap filling CA.  Recently switched to Weld-On #16.  This fuses PLA together, like a plastic cement does with styrene.
 
I coat both surfaces and press the pieces together hard for a few moments.  Excess glue wipes up easily from along the seam.  If not pressed hard together, the joint might pop apart easily.  When it does get a good seal, the joint stays fused.

 

https://www.amazon.com/dp/B003HNFLMY