Jump to content

New Kato DCC EM13 issue


EdF

Recommended Posts

I've recently received 3 new Kato sets and 2 of them have issues getting anout contact between the EM13 chip and the motor tabs.

 

On the E233 Chuo 130th, they looked like they just didnt bend back far enough to reach the contacts on the chip, i curled them more and it worked.  Just put the chip in my TEM and seems to have the same issue.  My E655 was fine though.

 

Anyone else seen issues?

Link to comment

Do you have a photo of the issue?  Its a little hard for me to figure out the problem from a description.  The only train I've had issues with an EM13 is with the early kato GS4.

Link to comment

Yes, every now and then I get issues with the Kato EM13 not making good contact with the copper strips. Also with their function decoders FL12.

Usually fixed by a little shimming or in some cases adding a litlle solder

 

Let me say that ZIMO is now making an alternative to the KATO originals, they work better I'd say....

Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...