Jump to content

Kato Unitram dimensions and products


Hayashi

Recommended Posts

I have found some space in my railroad plan for small Unitram route. However, I need to determine dimensions of the Unitram track plates. I know they are built on 124mm x 124mm squares, but it appears the 124 long roads are not 124 wide. How wide are they?

 

I will run a loop around my viaduct station, but in front of it I only have space for the Unitram track and one 2-lane roadway (i.e., not a 4-lane road with a Unitram track down the middle). Looking at the illustration below, it appears the left-hand plates are 124x124 with track on one side and road on the other. But what are the dimensions of the road and track plates on the right-hand side (i.e., the 4-lane side)? My loop would be 10x 124s long with the 2-lane roadway plus the in front of the station and only Unitram track behind it plus the curves. I was hoping to use some of the leftover road pieces from a V50 or some other expansion set since Kato doesn't seem to make individual road pieces.

 

Another question is: Does using 186mm long Unitram track bugger up attaching with the standard 124x124 plates or should I stay with just using 124mm long track?

Unitram dimensions.png

Link to comment
On 9/10/2018 at 7:11 PM, Hayashi said:

A follow up. I know the roads look like they are 62mm wide, but I want to verify it.

 

I have just measured it, roads are 50 mm wide.

Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...